Filter
Top Products
P. 10 User Guide
To leave the vehicle in Idle Mode if your vehicle has an automatic transmission:
1. With the engine running, make sure to release the brake pedal and press the UNLOCK
button (to unlock the doors, if installed) or the START/STOP button on the remote control
until the parking lights come on or you hear a series of clicks.
2. Remove the key and exit the vehicle. The engine will continue running.
3. Lock the doors if needed.
The engine will continue running until the user re-enters the vehicle or until the expiration of the
Engine Run Time.
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine
as that used for Ready Mode; for the last step, the
TRUNK button is pressed instead of the other
buttons.
1. Ensure that all the doors, hood and trunk are closed and that the shifter is in the neutral
position.
2. With the engine running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3. Within 20 sec. of engaging the parking brake, push LOCK, UNLOCK or START/STOP on the
transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key; the engine will continue running.
5. Exit the vehicle and close all doors, hood and trunk.
6. Press the TRUNK button until you hear a chirp (the doors will lock if remote door lock is
installed, and the system will arm).
If the pre-programmed run time expires or if the user shuts down the engine by remote control, the
vehicle will be in Ready Mode.
Caution!!! Do not leave children or pets unattended in a vehicle running in Idle Mode.
Turbo Mode
If turbo mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle (the unit will take over the vehicle and keep it running for 60 seconds or until it is
shut down by remote control). The vehicle will remain in Ready Mode.
If your vehicle has an automatic transmission
, proceed as follows to set the system in
Turbo Mode:
1. With the engine running, make sure to release the brake pedal and press the LOCK
button on the transmitter until the parking lights come ON or you hear a series of clicks.
2. Remove the key from the ignition switch. The engine will continue running.
3. Exit the vehicle and close all doors, hood and trunk.
4. Press the TRUNK button (this will lock the doors; the engine will shut down after
60 seconds of Turbo Mode).
If your vehicle has a manual transmission
, follow all steps of the Ready Mode routine, to
activate Turbo Mode:
1. Ensure that all the doors, hood and trunk are closed and that the shifter is in the neutral
position.
2. With the engine running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3. Within 20 sec. of engaging the parking brake, press LOCK, UNLOCK or START/STOP on the
transmitter.
The parking lights will flash 3 times quickly and remain lit.