Filter
Top Products
User Guide P. 11
4. Remove the key; the engine will continue running.
5. Exit the vehicle and close all doors, hood and trunk.
6. Press and hold either:
a. LOCK to lock the doors and shut down the engine after 60 sec.;
b. UNLOCK to unlock the doors and shut down the engine after 60 sec.;
c. START/STOP to shut down the engine immediately, without affecting the doors (this will
bypass Turbo Mode).
d. TRUNK to set the vehicle into idle mode.
Valet Modes
When your vehicle is in valet mode, the remote starter functionalities and alarm are disabled. If the
vehicle needs to be serviced, or if you park it indoors, valet mode will prevent the engine from
being remote started accidentally.
Valet Mode Using the Valet Switch (if installed)
To put the system into valet mode:
1. Turn the key to the IGNITION ON (RUN) position.
2. Within 3 sec., press the valet button for 1 second.
The parking lights will flash three times to indicate that the vehicle is now in valet mode.
3. Turn the key to the OFF position.
The LED on the antenna will come ON solid.
To take the system out of valet mode:
1. Turn the key to the IGNITION ON (RUN) position.
2. Within 3 sec., press the valet button for 1 second (the LED will turn OFF or start to flash).
The parking lights will flash twice to indicate that the vehicle is now out of valet mode.
The LED will go out or start to flash.
Note: Once valet mode is activated, the remote starter and alarm functions will be disabled.
Ignition Valet
This feature will allow you to put your system into valet mode by using the ignition key instead of
the valet button (as above). Ignition valet can be used without a valet button installed.
To put the system into valet mode:
• Insert the key into the ignition switch. Turn the ignition ON then OFF 5 times in 10 seconds.
(Note: ON is the position before crank.)
The parking lights will flash three times to indicate that the system is now in valet mode.
The LED will turn ON solid.
To take the system out of valet mode:
• Insert the key into the ignition switch. Turn the ignition ON then OFF 5 times in 10 seconds.
(Note: ON is the position before crank.)
The parking lights will flash twice to indicate that the system is now out of valet mode.
The LED will go out or start to flash.
Note: Once the ignition valet is activated, the remote starter and alarm functions will be
disabled.
Remote Valet Mode
This feature will allow you to put your system into valet mode by using the transmitter instead of the
valet button (as above).
Getting into valet mode
• Hold the UNLOCK and START/STOP buttons simultaneously for 3 seconds.
The parking lights will flash 3 times.