Autostart AS-2510 TW Remote Starter User Manual


 
Parking Countdown
This version of the Countdown feature is particularly useful for keeping track of parking
meter time: the user may quickly set up the countdown in slices of 10 or 30 minutes using
the
and buttons (refer to the tables).
Melody Selection
The Remote Control allows the user to select which melodies are to be used upon the
following events: remote starting of the vehicle, the Alarm, ending of the countdown,
entering Cold Weather Mode. Melodies for these various events can be selected using the
button (refer to the tables).
Vibration Mode
Use this feature to replace audible signals with a vibration signal. Use the and
buttons to switch Vibration Mode ON and OFF (refer to the tables).
Power Saving Mode
When set to Power Saving Mode, the Remote Control will cease polling the Remote Starter
Module on a regular basis for status information. This will extend battery life. Use the
and buttons to switch Power Saving Mode ON and OFF (refer to the tables).
Remote Control Finder
This function allows the user to locate the Remote Control when it has been accidentally
dropped near the vehicle. Pressing the Valet Button and holding it down for 3 seconds (or
until the Parking Lights flash five times) will cause the Remote Control to start beeping for
one minute. The beeping will stop by itself after one minute, or it can be switched off by
pressing the Lock (
) or the Unlock ( ) button on the Remote Control.
LCD Remote Operation
(First Car Control)
NOTE:
The following section explains the functions the Transmitter can provide. If you wish to exit
a function while you are accessing it, simply stop and wait at least 10 seconds, the
Transmitter will return to normal.
Basic Vehicle Operations
FUNCTION BUTTON PRESSED ICON BUZZER INSTRUCTIONS /DESCRIPTION
LOCK 1 Beep
LOCK AND ARM THE STARTER
KILL
UNLOCK 2 Beep
UNLOCK AND DISARM THE
STARTER KILL
TRUNK OR AUX 3 1 Beep TRUNK OUTPUT
START *
(See Runtime
Options below)
+
MELODY START THE ENGINE
STOP None MELODY STOP THE ENGINE
Light ON ON for 10 seconds
Press
once
P. 5 User Guide AS-2510 TW