Filter
Top Products
AS-1412 User Guide P. 3
ensure that the windshield wiper and headlight switches are OFF. Leaving the headlight
switch
ON on certain types of vehicles could cause them to remain ON even after the remote
starter shuts down, resulting in a dead battery.
Driving Off
With the vehicle running under remote control, press button , to DISARM the module and to
UNLOCK the doors (if installed). Enter the vehicle and do the following:
x Turn the ignition key to the IGNITION ON (RUN) position.
x Press the brakes to disengage the remote starter unit.
You are now ready to drive off.
Caution: do not turn the key to the CRANK position with the engine running. This will cause
the starter motor to re-engage, unless your vehicle is equipped with the Start Kill / Anti-
Grind Feature (Optional).
Idle Mode
This feature allows the user to engage the remote starter to take over the vehicle while it is
already running with the key in the
IGNITION switch. The vehicle will keep running for the pre-
programmed run time, or until it is shut down by remote.
Caution: Do not leave children or pets unattended in a car running in Idle Mode.
To activate Idle Mode:
To enable Idle Mode, press and hold buttons ,
or,, on your remote transmitter while the
engine is running.
Note: When enabling Idle Mode, pressing
button , will automatically unlock the doors.
The parking lights will come
ON. Remove the key, exit the vehicle and lock the doors (if
desired). The engine will continue running and will turn itself
OFF when the pre-programmed
run time expires.
Valet Mode
Ignition Valet
The system can be placed in Valet Mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine
from being accidentally started by remote control.
To ENTER Valet Mode
1. With the key in the Ignition switch, turn the key to the ON (RUN/IGNITION) and then OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash 3 times indicating the Module is now in Valet Mode.
The LED will turn ON solid.
To EXIT Valet Mode
1. With the key in the Ignition switch, turn the key to the ON (RUN/IGNITION) and then OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash twice indicating the Module is now out of Valet Mode.
The LED will turn OFF.