Filter
Top Products
RF-502
7
1. Open any door or other protected opening. The siren will sound
instantly, and the lights will flash.
2. If the pre-warning feature is activated, the RF-502’s SIS-5 impact
sensor will respond to a light shock with a chirp sound, and trigger
the alarm when a heavier shock is detected. (Please refer to A-4 for
details).
3. If optional sensors have been installed, arm the RF-502 and test
according to the directions of the particular sensor installed.
If triggered in the armed condition, the RF-502 will sound its siren and
flash the lights for 60 seconds; then it will stop and automatically reset
and rearm. If the violation continues, the alarm will sound and lights will
flash for two 60 second cycles.
K. PROGRAMMING THE REMOTE TRANSMITTERS
NOTE: Each time the programming mode is entered, all programmed
transmitter codes will be automatically deleted and must be re-
programmed. This is an important security feature. If any transmitter is
lost or stolen, enter the programming mode and re-program existing
transmitters. Transmitters can only be programmed by entering the
programming mode. Existing codes will remain in memory even if
power to the RF-502 is disconnected.
To program the RF-502 transmitters, follow the directions as written
below, in their exact order!
1. Flip the VALET/OVERRIDE switch to "ON" position.
2. Turn the ignition switch to "ON", then "OFF", then immediately
3. Flip the VALET/OVERRIDE switch "OFF", "ON/OFF", "ON/OFF". The
siren will chirp one (1) time.