Auto Page RF-502 Automobile Alarm User Manual


 
RF-502
10
AUTOPAGE ALARM ACCESSORIES
AP-4000DX Paging System
Vehicle security paging was originated by AutoPage over 18 years ago.
The AP4000DX is our latest version providing a full four watts of output
power to signal a handsome belt-clip paging receiver indicating your
RF-502 has been triggered, even if you cannot hear the siren.
RS-32 Dual Stage Perimeter Protection Sensor
The RS-32 utilizes microwave technology that emits dual protective
fields. The easy and separate adjusment of the exterior and interior
fields allows the RF-502 to be armed and provide maximum protection
in convertible vehicles parked with the top down, and equally good
protection in enclosed vehicles.
SIS-3 Glass/Shock Sensor
Our top selling and extremely reliable electronic glass/shock sensor, the
SIS-3 can be finely adjusted for each installation, from sports cars to
trucks. When properly adjusted, it virtually eliminates false triggers
typically caused by inferior sensors.
SIS-10 Air Movement Sensor
The SIS-10 super low frequency vibration sensor has successfully
integrated an electret electrostatic transducer and low pass filter,
creating a new and cost effective air movement sensor. If installed in a
closed vehicle, any movement of air inside the vehicle which may be
caused by opening a door will trigger the sensor. Applications of the
SIS-10 are limitless. It will be ideal to monitor a vehicle’s doors, trunk or
hatch, an RV, a closed cabin on a vessel and so on. The SIS-10 can
also replace glass breakage sensors. The advantage of the SIS-10 is
that a single SIS-10 can cover all the doors, rear hatch, windows and
sun roof even if there is no pin switch. Like other AutoPage SIS