Filter
Top Products
RF-302
2
3. PANIC FUNCTION
The RF-302 remote control may be used as a remote panic switch to
trigger the siren in cases of emergency. To activate the PANIC
FUNCTION press and hold the ON/OFF button on the remote transmitter
for a minimum of 3 seconds. The siren will sound. To stop the PANIC
FUNCTION press the ON/OFF button on the transmitter.
4. THE PRE-WARNING SENSOR CIRCUIT (If installed)
The RF-302 offers an option to pre-warn possible violators with siren
chirps before triggering the alarm. The alarm will trigger with the third
violation within 15 seconds. Purchase of an optional sensor will be
required.
To delete the pre-warning sensor, press the button again within 5
seconds after arming. The siren will confirm deletion with a low chirp.
NOTE: Deleted sensor(s) will return to normal operation upon
disarming the RF-302. Sensor(s) deletion procedure must be followed
each time the RF-302 is armed. This operation deletes only the pre-
warning sensor of the alarm.
5. CHANGING THE REMOTE TRANSMITTER BATTERY
The RF-302 remote transmitter uses one (1) 12 volt miniature battery,
#EL12, #VR22, or Radio Shack #23-144. It will provide approximately
one year of operation before replacement is necessary.