Filter
Top Products
Orange Wire : 300 mA Ground Output When Armed - N. C. Starter Disable
This wire is provided to control the starter cut relay. Connect the orange wire to terminal 86 of the relay.
Connect relay terminal 85 to an ignition wire in the vehicle that is live when the key is in the on and crank
positions, and off when the key is in the off position. ( This is where the yellow wire from the alarm should be
connected ).
Cut the low current starter solenoid wire in the vehicle, and connect one side of the cut wire to relay terminal
87A. Connect the other side of the cut wire to relay terminal 30.
Note : This is a normally closed starter cut arrangement, and when power is removed from the
security system, the starter disable feature will not operate, allowing the vehicle to start.
Audiovox does not recommend using the Orange wire to interrupt anything but the starting
circuit of the vehicle.
Mini 9 Pin Edge Connector :
Light Green Wire : ( - ) Instant Trigger Zone 1
This is an instant on ground trigger wire. This wire ( zone ) should be reserved for connection to optional
ground output trigger devices such as motion and / or shock impact sensors.
White w/ Blue Trace Wire : Headlight Output - Arm & Disarm
The white w/ blue trace wire is provided to control the optional headlight illumination feature of the system.
This is a transistorized, low current ( 300 mA ) output, and should only be used to drive an external relay coil.
This wire provides a 30 second ground signal whenever the system is remotely armed or disarmed..
Connect the white w/ blue trace wire to terminal 86 of the AS 9256 relay ( or an equivalent 30 Amp automotive
relay ), and connect relay terminal 85 to a fused + 12 VDC battery source. Connect relay terminal 87 to one
of the low beam headlight wires in the vehicle, and connect relay terminal 30 to either chassis ground or a
fused ( 15 Amp Min)+12VDCbattery source, depending on the polarity of the headlight circuit in the
vehicle.
Yellow Wire : + 12 VDC Ignition Source
Connect this wire to a source that is live when the key is in the on and crank positions. Be sure that this
source is off when the key is in the off position.
Purple Wire : + Door Trigger
If the vehicle’s door courtesy light switches havea+12volt output when the door is opened ( some Fords and
some Imports ), you must connect this wire to the positive output from one of the door switches. In most
cases, the purple wire will only need to be connected to one door switch, no matter how many doors the
vehicle has.
WARNING : Do not use the purple wire if the vehicle has ground output type door switches. ( see Brown
Wire).
Brown Wire : - Door Trigger
If the vehicle’s courtesy light switches havea(-)ground output when the door is opened ( GM and most
Imports ), you must connect this wire to the negative output from one of the door switches.
WARNING : Do not use the brown wire if the vehicle has + 12 volt output type door switches. ( see Purple
Wire ).
Dark Green Wire : ( - ) Instant Trigger Zone 2
This is an instant on ground trigger wire. It must be connected to the previously installed hood and trunk pin
switches.
Page 4