Filter
Top Products
128-8787
10 of 24
10
Purple Wire: (+) Door Trigger Input
If the vehicle's door courtesy light switches +12 volts when the door is opened (some Fords and some
Imports), you must connect this wire to the positive output from one of the vehicle's door pin switches. In
most cases, the Purple wire will need to be connected to only one door switch no matter how many doors
the vehicle has as most door lighting circuits are wired in parallel.
Note: For vehicles with interior delay lighting see programming under title "Completing The Installation".
Positive Door Switch Wiring Detail
Hood Pin Switch Detail
Dark Green Wire: (-) Instant Trigger Input
This is the instant on ground trigger input wire. This wire must be connected to the hood and or trunk pin
switch or switches previously installed.
Note: This wire will be shunted when remote control channel 3 is accessed, (trunk release). This wire will
remain shunted all the while there is ground present and for 5 seconds after the ground is removed.
This allows the operator to open the trunk via the remote transmitter without having to first disarm
the alarm system. See below for wiring detail.