Filter
Top Products
To program these selectable features:
1. Start with the programming switch in the OFF position.
2. Turn the ignition key to the ON position.
3. Flip the program switch ON - OFF - ON - OFF - ON - then OFF.
4. Immediately turn the ignition key OFF, then back to ON.
5. Flip the program switch ON - OFF - ON - then OFF.
6. Usebutton1o nthetransmittertoadvancetothefeaturethatyouwanttochange. EXAMPLE-Ifyouneedtochange
programmable featurenumber 3, pressand release button 1on the transmitter3 times insuccession. The
parking lights will flash 3 times confirming that selected feature 3 can now be programmed.
7. Use button 2 on the transmitter to change the selection of the programmable feature. If you are not sure
what the setting for any feature is, press button 2 one time, the parking lights will flash once or twice
indicating the features setting.
Note: Once you enter the feature programmingmode, donot allowmore that 15seconds topass between
steps, or the programming will be terminated.
2. Programming Tach Rate:
NOTE: All applications require that tach be programmed.
NOTE: All applications require that tach be programmed.
The unit willnot operate unless tach isprogrammed. If an attempt is madeto start the vehicle viathe remote
start without first programming tach, theunit will flash the parking lights 7 times indicating tachhas not been
learned andstored. If the tachrate is notproperly programmedto the specificvehicle, theunit may notrealize
that the vehicle is running in certain instances reengage the starter motor.
The APS 675 Remote Car Starter will learn the tach rate of most vehicle's single ignition coils, multiple coil
packs, and or single injector. To learn tach;
1. Start with the programming switch in the OFF position.
2. Turn the ignition key to the ON position.
3. Flip the program switch ON - OFF - ON - OFF - ON - then OFF.
4. Immediately turn the ignition key OFF.
5. Flip the program switch ON, then start the vehicle using the ignition key.
6. When the unit senses the tach signal, the parking lights will begin to flash.
7. Flipthe program switch OFF. The parking lights willturn on for 3seconds to indicate that thetach signal
is stored and the unit is now out of the program mode.
3. Diagnostics:
1. Be sure that programmable feature number #7 is set to the "Diagnostics On" mode.
2. First flip the program switch on, then turn the ignition key to the ON position.
3. The lights willflash, and number of flashes will indicate the reason for shutdown on the last remote start
attempt. The indications are as follows.
10 or 15 Minute Run Timer Expired
Low or No Tach Signal (RPM)
Positive Or NegativeShutdown Wire Activated
Control Switch Moved to Off Position
RF shutdown, Remote signal received, or manual start trigger wire reactivated.
High RPM SignalReceived
Tach Has Not Been Programmed
1 Flash
2 Flashes
3 Flashes
4 Flashes
5 Flashes
6 Flashes
7 Flashes
12