Audiovox APS 600 Automobile Alarm User Manual


 
Page 8
USING THE CUSTOM CODE MANUAL OVERRIDE
It is very important that you understand how to operate the manual override feature, as
there may a time that you will need to bypass the alarm when your transmitter is not
working. You should also write down your personalized code number, and keep it in a safe
place for future reference.
To by pass the alarm,
1. Open the door. The alarm will sound.
2. Turn the ignition key to the on position. The alarm will stop for three seconds,
then the siren will begin counting with long chirps.
3. As soon as the chirp that corresponds with your first digit sounds, quickly turn
the ignition key ;
1. off then on if your second digit is 1
2. off then on twice if your second digit is 2
3. off then on three times if your second digit is 3.
4. The alarm will stop sounding, and you can now start the vehicle.
EXAMPLE : To override the system using the example 52 above, you would,
1. Open the door. The alarm will sound.
2. Turn the ignition key to the on position. The alarm will stop for three seconds,
then the siren will begin counting with long chirps.
3. As soon as the fifth chirp has sounded, quickly turn the ignition key off then
on then off then on.
4. The alarm is now disarmed.
IMPORTANT NOTE : If you elect not to program a personalized manual override code,
the factory pre set code is 11. To override the alarm with this code,
1. Open the door. The alarm will sound.
2. Turn the ignition key to the on position. The alarm will stop for three seconds,
then the siren will sound a long chirp.
3. As soon as the chirp has sounded, quickly turn the ignition key off then on.
4. The alarm is now disarmed.
ELIMINATING THE NORMAL ARM / DISARM CHIRPS
As explained earlier in the manual, you can eliminate the chirps selectively any time you
arm or disarm the system simply by holding the ARM / DISARM button for two seconds. If
you find the normal arming and disarming chirps annoying, they can be turned off perma-
nently, eliminating the need to hold the ARM / DISARM button for two seconds. To do this,
1. Start with the valet switch in the off position, then turn the ignition key on then
off.
2. Within 10 seconds, move the valet switch to on then off three times.
3. If the chirps were on before you started, then you will hear 2 chirps indicating
they have been turned off.
If the chirps were off before you started, then you will hear one chirp indicating
they have been turned on.
NOTE : Whenever the chirps are by - passed, the 4 chirp intrusion indicator and 3 chirp
defective zone indicator will always operate. Since these are important warnings to you
that something has happened, they cannot be eliminated.