Filter
Top Products
128-7404A
15 of 24
Page 15
will indicate count down timer based on the 5, 10, 15, or 20
minute run time set up by your installation center. When the unit
shuts off the exhaust indication will turn off and the transmitter
will play a melody. If text mode was selected, the screen will
scroll the words Engine Running.
Note Engine can be started in many modes armed, disarmed,
valet, etc... The screen shown is Locked/Armed and running.
When Panic Mode has been activated and the system is armed the vehicle's
lights, the lock and the siren icon will flash on the LCD screen. If the system is
disarmed and the Panic Mode is activated, the lights, siren, and the unlock
icons will flash on the LCD screen. If in text
mode, the words Panic will flash on and off until
the mode times out and the next remote com-
mand is executed.
When ever the vehicle is operated from the two way transmitter, the unit will
beep responsive to the function executed at the vehicle. 1 beep when armed, 2
beeps when disarmed, etc... at times It may be inconvenient or too noisy to
hear the beep tones, so the system allows you to set the unit for vibrate mode.
To toggle on or off beep tones/vibrate, locate this feature in the
transmitter program section and set to vibrate. The icons shown
left will appear in the upper left of the screen.
If the alarm system has been triggered, the icon displayed on
the transmitter LCD will indicate which zone has been activated,
as well sound the beep tones, or vibrate dependent upon the
setting as shown above. The following trigger patterns will be
displayed.
Triggered and the entry attempt was made to one of the vehicle Doors.
Triggered and entry attempt was made to the vehicles Hood
or
Trunk.
Triggered and entry attempt was made to the vehicles glass, or
the vehicle has been hit or bumped hard enough to cause a
response from the vibration detector.
ADDITIONAL ICONS THAT MAY BE DISPLAYED ARE:
If the arm/disarm chirp tones have been turned off at the vehicle,
when you arm, or disarm, the display will indicate this as shown
and there will be no arm/disarm chirps at the transmitter. This is