Filter
Top Products
Page 6
arm/disarm button of your keychain transmitter. Enter the vehicle and turn the ignition key to
the on position.
CAUTION ! Do not turn the key to the start position. This will cause the starter motor to
engage with the already running engine which could result in damage. Step on
the brake pedal to disengage the remote start unit. The vehicle will continue to
run but now on it's own power.
NOTE: The engine will stop running before the expiration of the pre-programmed run timer if
you complete any of the following:
1. Press and release channel 2 of your keychain transmitter two times within 2 seconds.
2 . Depress the brake pedal.
3. Open the hood.
4. Move the red handled control switch to the off position.
5. Race the engine to above 4000 RPM.
OPERATING ON AUT OMATIC STARTUP TIMERMODE
The APS-775 has the ability to automatically start the vehicle every 2 or 4 hours over a
48 hour period. This feature is especially useful in cold climates where the only means to
keep the engine and engine fluids warm is to periodically start the engine.
CAUTION ! Be certain that the vehicle is outdoors before using this or any remote vehicle
starting device. A running engine produces dangerous carbon monoxide fumes
which can be harmful or fatal if prolonged exposure occurs. DO NOT remote
start the vehicle if it is garaged.
TO BEGIN THEAUTOMA TIC START UP TIMER
1. Turn the ignition key on then off.
2. Within 10 seconds, activate the RF start command two times. (Push the second channel
button of your keychain transmitter 4 times).
The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is
activated.
The vehicle, ona2or4hour interval basis, will automatically start, run for the pre-programmed
time (10 of 15 minutes), and then shut off. This will continue for 48 hours.
NOTE: The automatic start up timer can also be initiated from the keychain transmitter. To do
this:
1. Start the vehicle using the keychain transmitter by pressing and releasing the second
channel transmitter button 2 times.
2. Shut off the vehicle using the keychain transmitter by pressing and releasing the second
channel transmitter button 2 times.
3. Within 10 seconds of step 2, activate the RF start command two times. (Push the second
channel button of your keychain transmitter 4 times).
The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is
activated.
CANCELING THE AUT OMATIC START UP TIMER
To cancel the automatic start up timer do one of the following;
1 . Start the vehicle manually with the use of the ignition key and depress the brake pedal.
2 . Remote start the vehicle using your keychain RF transmitter.