Filter
Top Products
Page 4
INTRUSION W ARNING SIGNAL
This system will inform you if an intrusion attempt has occurred while you were away from
the vehicle. Upon disarm, the siren will chirp 4 times and the parking lights will flash 3 times.
Enter the vehicle and before turning on the ignition switch, observe the LED flash pattern.
If the LED flashes one time...pause, one time...pause etc., then an intrusion attempt was
made by impact or a strong vibration that the shock sensor detected. Check the vehicle for
possible damage to the glass or body panels.
If the LED flashes two times...pause, two times...pause etc., then an intrusion attempt was
made to open the hood, trunk, or by an accessory triggering device. Check the vehicle for
indications of forced entry to these openings.
If the LED flashes three times...pause, three times...pause etc., then an intrusion attempt
was made to the vehicle doors. Check all doors for indications of forced entry.
Note: The LED intrusion warning indications are stored in the system's memory and will be
erased when the ignition switch is turned on.
VALET/SYSTEM OVERRIDE SWITCH
The valet switch allows you to temporarily by-pass all alarm functions, eliminating the need to
hand your keychain transmitter to parkingattendants orgarage mechanics. When the system
is in the valet mode,all alarm functions are by-passed, however the remote panic feature, and
the optional remote door lock/unlockwill remain operational. To enter the valet mode:
1. Start with the valet switch in the "off" position
2. Turn the ignition switch to the "on" position.
3. Within 10 seconds of step 2, move the valet switch to the "on" position.
The dash mounted LEDwill turn on solid indicating that the valet mode has successfully been
entered.
To return to the normal, (alarm mode), operation, move the valet switch to the "off" position
any time the ignition switch is in the "on" position.
Note: In the event that you lose your keychain transmitter or the transmitter fails to operate
the alarm system, the valet switch can be used to disarm the alarm. To disarm the alarm:
1. Open the door with the vehicle door key. (The siren will sound)
2. Turn the ignition switch to the "on" position.
3. Move the valet/override switch to the "on" position.
The system will disarm and the vehicle can be operated normally.
Always remember to move the valet switch to the "off" position to ensure the vehicle
remains protected at all times.
ELIMINATING THE NORMAL ARM/DISARM CHIRPS
You can selectively eliminate the normal arm & disarm chirp s by holding the transmitter button
slightly longer when arming or disarming. This will prevent the siren chirps for one arm or
disarm cycle. If you find this inconvenient and wish to eliminate these chirps permanently,
1. Start with the valet switch in the 'off" position.
2. Turn the ignition switch 'on" then 'off".
3 . Within 10 seconds of turning off the ignition, move the valet switch 'on", "off', "on", "off",
"on", "off".
4 . If the chirps were on before you started, the siren will emit 2 short chirps indicating that
the chirps are now off. If the chirps were off before you started, the siren will emit one