Filter
Top Products
oWhen
the lock button
on
the transmitter
is
pressed and the command
is
received and
l::Jacted upon by the unit
in
the vehicle, this
LED
will light
Red
and the transmitter will beep
once, then
will continue flash once every 10 seconds
so
you, at a glance,
can
determine the
status of your vehicle or determine the state it
was
last left
in.
The Unlock
LED
Indicates:
.....r-
When the unlock button
on
the transmitter
is
pressed and the command
is
received and
\.::)
acted upon by the unit
in
the vehicle, this
LED
will light
Red
and the transmitter will
beep twice, then will continue flash once every
10
seconds
so
you,
at
a glance, can
determine the status of your vehicle or determine
the
state it was last left
in.
The Key LED Indicates:
D=
When the key transmitter button
is
operated two times
in
succession and
the
start
command
is
received and acted upon by the unit
in
the vehicle, this
LED
will light
Red
and the transmitter will play the remote start melody indicating that the vehicle
is
running
and
will continue to
run
for the preset period
as
determined at time of installation.
If
you
wish to prematurely shut down the remote start while the vehicle
is
still running, simply press
the
key transmitter button two times
in
succession.
The vehicle
will tum off and the Not Key
LED
will turn
on
breifly.
The Not Key
LED
Indicates:
~
Whenever the remote start turns off, either
by
intentional activation
on
the part of the
operator, or
by
timing out after the preset
run
timer, this
Not
Key
LED
will
light
Red
breifly and the transmitter will play the
shu1
down melody.
NOTE: If the vehicle
is
under the control of the Remote Start and the vehicle
is
running,
when either Lock or Unlock button
is
pressed,
the
Lock or Unlock
LED,
and
the
Start
LED
will
turn on momentarily.
Two Way Transmitter Operation:
The two way transmitter shown earlier
in
this manual operates similar to any transmitter with
the exception that it
will also indicate that the vehicle acted upon the command issued.
Locking: Press
and
release the Lock Icon Button
on
the transmitter and the unit, providing it
is
within range of the vehicle, will lock the vehicle doors and report back that
the
command
was
acted upon
by
breifly tuming
on
the Lock
LED
and beeping once. This lock
LED
will
flash 1 time every
10
seconds until the Unlock command
is
issued.
Press and hold for lock button for three seconds causes
the
unit to
go
into the car finder
mode. See car finder reference shown earlier
in
this manual.
Unlocking: Press
and
release
the
Unlock Icon Button
on
the transmitter and the unit,
providing
it
is
within range of the vehicle, will unlock the vehicle doors and report back that
the command was acted upon
by
breifly tuming
on
the Unlock
LED
and beeping twice. This
unlock
LED
will flash 1 time every
10
seconds until the lock command is issued.
Press and hold for unlock button for three seconds causes the unit
to
go into
the
car finder
mode. See car finder reference shown earlier
in
this manual.
Starting The Vehicle: Press
and
release two times
in
succession the Key Icon Button
on
the
transmitter and the unit, providing it
is
within range of the vehicle, will Start the vehicle and
report back that
the
command
was
acted upon
by
flashing 5 times the Key
LED
and
playing
the start melody.
Operating
the
lock button or unlock button while the unit
is
under the
control of the remote start will cause the
lock or unlock
LED
to light breifly, the transmitter
will chirp once for lock or twice for unlock, and along with that,
the
Key
LED
will turn
on
for 4
seconds indicating the vehicle is
still running under command of the remote start unit.
The Option Button: Press
nd
release the OPT Button
on
the transmitter and the unit,
128-6688
3
of
4