Filter
Top Products
Page 1
Model APS-25HJ
Installation Manual
PROGRAMMABLE FEATURES
RF Programmable Features :
Feature Selection 1 Chirp 2 Chirps Default
First 1 Second Door Locks 3.5 Second Door Locks 1 Second
Second Auto Lock On Auto Lock Off Auto Lock Off
Third Auto Unlock On Auto Unlock Off Auto Unlock Off
Fourth Passive Door Locks Active Door Locks Active Locks
Fifth Passive Arming Active Arming Passive Arming
Sixth V oltage Sense On Voltage Sense Off Volt age Sense Off
Seventh Hi-Jack Start Timer 15 Sec. Hi-Jack Start Timer 45 Sec Start Timer 45 Sec.
Eighth Hi-Jack Feature On Hi-Jack Feature Off Hi-Jack Feature On
Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin switch in order to begin
the passive arming sequence.
To program these selectable features;
Action System Response
Turn ignition on No response
Flip valet switch on then off 3 times 1 Chirp - LED 1 flash
Within 3 seconds, turn ignition Off Short chirp, then long chirp
First Then On 1 chirp = 1 second door locks
Press transmitter button 1 to change 2 chirps = 3.5 second door locks
or
Second Flip valet switch on then off 2 chirps = auto locks off
Press transmitter button 1 to change 1 chirp = auto locks on
or
Third Flip valet switch on then off 2 chirps = auto unlock off
Press transmitter button 1 to change 1 chirp = auto unlock on
or
Fourth Flip valet switch on then off 2 chirp = active locks
Press transmitter button 1 to change 1 chirps = passive locks
or
Fifth Flip valet switch on then off 1 chirp = passive arming
Press transmitter button 1 to change 2 chirps = active arming
or
Sixth Flip valet switch on then off 2 chirps = voltage sense featureoff
Press transmitter button 1 to change 2 chirp = voltage sense feature on
or
Seventh Flip valet switch on then off 2 chirp = Hi-jack start timer 45 seconds
Press transmitter button 1 to change 1 chirps = Hi-jack start timer 15 seconds
or
Eighth Flip valet switch on then off 1 chirp = Hi-jack feature on
Press transmitter button 1 to change 2 chirps = Hi-jack feature off
or
Flip valet switch on then off Exit Program Mode
or
Turn the ignition switch off Exit Program Mode
Note : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the programming
will be terminated.