Filter
Top Products
To Remote Start The Vehicle:
Press and release channel 2 of your keychain transmitter two times within 2 seconds.
The vehicle will start and remain running for the pre-programmed 10 or 15 minutes. As
a visual indication, the parking lights will flash or turn on depending on the programming
set up by your installation center.
When you arrive at your vehicle, disarm the alarm system by pressing and releasing the
arm/disarm button of your keychain transmitter. Enter the vehicle and turn the ignition
key to the on position.
CAUTION! Do not turn the key to the start position. This will cause the starter motor to
engage with the already running engine which could result in damage. Step
on the brake pedal to disengage the remote start unit. The vehicle will
continue to run but now on it's own power.
NOTE: The engine will stop running before the expiration of the pre-programmed run
timer if you complete any of the following:
1. Press and release channel 2 of your keychain transmitter two times within 2 seconds.
2. Depress the brake pedal.
3. Open the hood.
4. Move the red handle control switch to the off position.
5. Race the engine to above 4000 RPM.
OPERATING ON AUTOMATIC START UP TIMER MODE
The AA-RS40CS has the ability to automatically start the vehicle every 2 or 4 hours
over a 48 hour period. This feature is especially useful in cold climates where the only
means to keep the engine and engine fluids warm is to periodically start the engine.
WARNING! Be certain that the vehicle is outdoors before using this or any remote ve-
hicle starting device. A running engine produces dangerous carbon mon-
oxide fumes which can be harmful or fatal if prolonged exposure occurs.
DO NOT remote start the vehicle if it is garaged.
TO BEGIN THE AUTOMATIC START UP TIMER
1. Turn the ignition key on then off.
2. Within 10 seconds, activate the RF start command two times. (Push the second
channel button of your keychain transmitter 4 times).
The parking lights will flash and the siren will chirp 4 times indicating the timed start
mode is activated.
The vehicle, on a 2 or 4 hour interval basis, will automatically start, run for the pre-
programmed time (10 of 15 minutes), and then shut off. This will continue for 48 hours.
NOTE:The automatic start up timer can also be initiated from the keychain transmitter.
To do this:
1. Start the vehicle using the keychain transmitter by pressing and releasing the
second channel transmitter button 2 times.
2. Shut off the vehicle using the keychain transmitter by pressing and releasing the
second channel transmitter button 2 times.
3. Within 10 seconds of step 2, activate the RF start command two times. (Push the
second channel button of your keychain transmitter 4 times).
The parking lights will flash and the siren will chirp 4 times indicating the timed start
mode is activated.
Page 6