Filter
Top Products
ignition key, examine the dash mounted LED's flash pattern. The number of flashes
identifies the triggered zone. For additional information, refer to INTRUSION WARNING
SIGNALS found later in this manual.
INTRUSION WARNING SIGNAL
This system will inform you if an intrusion attempt has occurred while you were away
from the vehicle. Upon disarm, the siren will chirp 4 times and the parking lights will
flash 3 times.
Enter the vehicle and before turning on the ignition switch, observe the
LED flash pattern.
If the LED flashes one time...pause, one time...pause etc., then an intrusion attempt was
made by impact or a strong vibration that the shock sensor detected. Check the vehicle
for possible damage to the glass or body panels.
If the LED flashes two times...pause, two times...pause etc., then an intrusion attempt
was made to open the hood, trunk, or by an accessory triggering device. Check the
vehicle for indications of forced entry to these openings.
If the LED flashes three times...pause, three times...pause etc., then an intrusion
attempt was made to the vehicle doors. Check all doors for indications of forced entry.
Note: The LED intrusion warning indications are stored in the system's memory and will
be erased when the ignition switch is turned on.
VALET/SYSTEM OVERRIDE SWITCH
The valet switch allows you to temporarily by-pass all alarm functions, eliminating the
need to hand your keychain transmitter to parking attendants or garage mechanics.
When the system is in the valet mode, all alarm functions are by-passed, however the
remote panic feature, and the optional remote door lock/unlock will remain operational.
To enter the valet mode:
1. Start with the valet switch in the "off" position
2. Turn the ignition switch to the "on" position.
3. Within 10 seconds of step 2, move the valet switch to the "on" position.
The dash mounted LED will turn on solid indicating that the valet mode has successfully
been entered.
To return to the normal, (alarm mode), operation, move the valet switch to the "off"
position any time the ignition switch is in the "on" position.
Note: In the event that you lose your keychain transmitter or the transmitter fails to
operate the alarm system, the valet switch can be used to disarm the alarm. To
disarm the alarm:
1. Open the door with the vehicle door key. (The siren will sound)
2. Turn the ignition switch to the "on" position.
3. Move the valet/override switch to the "on" position.
The system will disarm and the vehicle can be operated normally.
Always remember to move the valet switch to the "off" position to ensure the vehicle
remains protected at all times.
ELIMINATING THE NORMAL ARM/DISARM CHIRPS
You can selectively eliminate the normal arm & disarm chirps by holding the transmitter
button slightly longer when arming or disarming. This will prevent the siren chirps for
one arm or disarm cycle. If you find this inconvenient and wish to eliminate these chirps
permanently;
Page 4