1. Start with the valet switch in the 'off" position.
2. Turn the ignition switch 'on" then 'off".
3. Within 10 seconds of turning off the ignition, move the valet switch 'on", "off', "on",
"off", "on", "off".
4. If the chirps were on before you started, the siren will emit 2 short chirps indicating
that the chirps are now off. If the chirps were off before you started, the siren will emit
one short chirp indicating that the chirps are now on.
NOTE: If the vehicle battery is disconnected then reconnected, the unit will return to the
default setting of chirps on. Repeat the above procedure to eliminate the
arm/disarm chirps.
REMOTE PANIC OPERATION
The arm/disarm button of your keychain transmitter also serves as a panic switch and will
turn the alarm on from the maximum operating range of the transmitter. In an emergency
situation, to use the panic feature, press and hold the arm/disarm button of your
keychain transmitter for 3 seconds. This will cause the lights to flash, the siren to sound,
and if the optional interior illumination circuit was installed, the interior light will flash.
To disengage the panic feature, press and hold the arm/disarm button for 3 seconds. If
you do not shut off the panic feature, the system will time out and shut off automatically
after 30 seconds.
During this mode, all normal transmitter functions are operational.
SAFETY (Red Handle) CONTROL SWITCH
The control switch allows you to temporarily disable the remote starting function of your
AA-RS40CS. To disable the unit, move the red handle control switch to the off position.
The control switch also allows you to select between 2 hour start up and 4 hour start up
when using the automatic start up timer mode. The factory preset start up time for this
mode is every 4 hours. To select between 2 or 4 hour start up timer:
1. Begin with the control switch in the on position
2. Turn the ignition switch on then off
3. Within 10 seconds, move the control switch off, on, off, on (2 switch cycles) to select
a 2 hour start timer. After 10 seconds expire, the parking lights will flash and the siren
will chirp 2 times confirming that the two hour start cycle is set. Or, within 10 seconds
move the control switch off, on, off, on, off, on, off, on (4 switch cycles) to select a 4
hour start timer. The parking lights will flash and the siren will chirp 4 times
confirming that the 4 hour start timer is set.
REMOTE STARTING THE VEHICLE
The AA-RS40CS
WILL NOT start the vehicle if any one of the following conditions exists:
1. The Vehicle Hood Is Opened.
2. The Gear Selector Is In Any Gear Other Then Park.
3. The Brake Is Depressed.
4. The Safety Control Switch Is In The Off Position.
WARNING! Be certain that the vehicle is outdoors before using this or any remote
vehicle starting device. A running engine produces dangerous carbon
monoxide fumes which can be harmful or fatal if prolonged exposure
occurs.
DO NOT remote start the vehicle if it is garaged.
Page 5