Filter
Top Products
9
PANIC
(903 only)
Panic mode is used to attract attention if you are in difficulties.
This command will not be executed if engine is kept running by ignition key. Use the stop command to abort panic mode or
depress brake pedal.
Press and hold, for at least 4 seconds, any of the
, (OPTION 1), OR (OPTION 2) buttons. This command activates
parking lights, horn, and dome light, depending on which is connected to system, for 30 seconds
or 60 seconds
depending on programming during installation.
CODE LEARNING OF ADDITIONAL TRANSMITTER(S)
Four different remote controls can be programmed for a given vehicle. If a fifth remote is added, the first remote is deleted.
Note: When the first code learning command is sent, all the old codes are cleared out. Therefore if you want to add a new
remote, all the old ones must be reprogrammed as well.
One or more remote transmitters can be added. To do this, programming is accessed as follows:
Open hood.
Insert key in the ignition and turn to the RUN position.
Apply the brakes once.
You now have 10 seconds to turn the key from RUN to the STOP position 3 times.
If this sequence is correctly carried out, the control module flashes parking lights (4 flashes). You may then
proceed to the next step.
Press any button on the new remote control. When access code of new remote control is memorized, the
control module will confirm with flashing parking lights (1 flash).
Repeat the above procedures for each remote control that has to be programmed (up to 4 remotes).
Apply the brakes.
New remote(s) is (are) now added to the system.
SAFETY CHECKS
In order to maintain a high safety standard, proceed with the following checks every month.
HOOD SWITCH
• Remote start your vehicle.
• Open hood.
Engine should stop as soon as hood is opened.
If engine does not stop immediately, turn main switch to OFF position and leave it off until situation is rectified.
Contact
your service centre.