AstroStart 903 Remote Starter User Manual


 
7
LOW TEMPERATURE MODE
(Model 903 only)
In Low Temperature (Sentinel) mode, system starts your engine
automatically when temperature falls below a preset level
(programmable during installation). See table. Factory default setting is
shaded.
Engine will run for programmed runtime (see table), after which system
will wait 2½ hours and then start engine again if temperature is still below
preset level. Factory default setting is shaded.
To activate/deactivate Low Temperature mode:
Option 1 press the
button
Option 2 press and buttons simultaneously
When mode is activated:
Parking lights will flash 4 times, then, if temperature is below preset level, engine will start.
If temperature is above preset level, system waits until it goes below preset level before starting.
In the case of a manual transmission vehicle, the system must have detected a valid security sequence to allow the
activation of Low Temperature mode. (see “Safety sequence for manual transmission vehicles” on page 3).
If system cannot execute command (for example, security sequence not valid, hood is open), confirmation will be different
(lights: 3).
When mode is deactivated:
Parking lights will flash twice to confirm that mode is deactivated. Applying brakes also deactivates Low Temperature mode.
LOCK/UNLOCK COMMANDS (903 ONLY)
(Option 2 only)
If your vehicle is equipped with electric door locks, several functions can be operated by remote control.
These features are optional and may require purchasing additional equipment. Consult your dealer for advice.
Following systems can be controlled:
Door locks.
Trunk or hatchback release.
Interior lights.
LOCK
Press the button. Doors are locked and parking light flashes once to confirm command has been received.
Parking light confirmation is sent as many times as command is repeated so you are sure that system has received the
command. Horn sounds once if option "Confirmation on 2nd lock" was set during installation.
Low temperature level is set to
-5°C (23°F) -20°C (-7°F)
-15°C (5°F) -30°C (-22°F)
Engine runtime (Low temp mode) is set to
2 minutes 8 minutes
4 minutes 18 minutes