AstroStart 4204-A Remote Starter User Manual


 
7
ACTIVATE / CANCEL UTILITY 2
-
- 1 - -
ACTIVATE / CANCEL UTILITY 3
-
-
- 1 - - -
ACTIVATE / CANCEL UTILITY 4
-
-
- 1 - - -
RUNTIME SETTING
-
- 1 - 4 - - -
START TEMPERATURE SETTING
-
- 1 - 4 - - -
DISPLAY START FAIL CODES
-
- 1 - 20 - - -
DISPLAY ALARM CODES *
- -
- 1 - 8 - - -
REMOTE CONTROL KEYPAD UN/LOCK
5 sec.
3 sec.
-
REMOTE CONTROL SILENT MODE (TOGGLE)
5 sec.
3 sec.
-
N
O CONFIRMATION SIGNAL IS SENT
* COMMANDS FOLLOWED BY AN ASTERISK (*) APPLY ONLY TO COMMAND UNITS EQUIPPED WITH A SECURITY SYSTEM.
THIS COMMAND TERMINATES THE RUNTIME, PANIC MODE AND ALARM STATUS. TEMPORARY VALET MODE IF ACTIVATED A SECOND TIME DURING REARMING DELAY.
NO CONFIRMATION IS SENT BACK IF THE ENGINE DOES NOT START. START CONFIRMATION CAN TAKE FEW SECONDS EXCEPT IF THE ENGINE IS ALREADY RUNNING.
D
EPENDING ON THE PROGRAMMED OPTION (AT INSTALLATION), THE TRUNK CONFIRMATION SHOWS THAT : THE TRUNK IS OPEN ; THE INPUT (FOR THE OTHER SENSOR) IS IN VIOLATION STATUS .
WHEN THE OPTION IS PROGRAMMED IN TRUNK MODE (OPTIONAL MATERIAL REQUIRED) AND THE TRUNK IS OPEN.
THIS CONFIRMATION WILL REPEAT ITSELF EVERY 5 MINUTES UNTIL THE TRUNK IS CLOSED.
WHEN THE DOOR AND TRUNK ZONE ARE IN VIOLATION AT THE SAME TIME, THE LCD DISPLAY WILL SHOW THE DOOR ZONE (EXCEPT IF THE DOME LIGHT IS ON BY THE SYSTEM).
NOTE THAT THE "UNLOCK" COMMAND IS EMITTED WHEN REMOTE IS PUT IN "SILENT" MODE. DO NOT FORGET TO LOCK THE DOORS. _ IF THE COMMAND CANNOT BE EXECUTED, THE LIGHTS FLASHES ONCE,
4204A : THE TRUNKICON DOES NOT SHOW, 2205A : THE
LED LIGHTS UP.
Confirmations emitted by vehicle
C
ONFIRMATIONS EMITTED BY THE VEHICLE ARE SENT AS SOON AS THE COMMAND IS RECEIVED BY THE START MODULE. IN MOST CASES, YOUR REMOTE STARTER WILL CONFIRM THAT THE COMMAND HAS
BEEN RECEIVED
, EITHER BY SOUNDING THE HORN, THE SIREN, OR BY FLASHING THE PARKING LIGHTS.
T
HE CONFIRMATIONS EMITTED BY THE PARKING LIGHTS ARE MANDATORY WHILE THOSE EMITTED BY THE HORN AND THE SIREN ARE OPTIONAL (PROGRAMMABLE) AND CAN REQUIRE CONNEXIONS AND
ADDITIONNAL EQUIPMENT AT TIME OF INSTALLATION
. MANY OF THESE CONFIRMATIONS DEPEND ON THE SYSTEMS STATUS WHEN THE COMMAND IS EMITTED. REFER TO PARAGRAPHS RELATING TO EACH
COMMAND FOR MORE DETAILS ON CONFIRMATIONS
.