Filter
Top Products
17
“P
ASSIVE ARMING" TYPE ANTITHEFT /
This type of antitheft system arms automatically when ignition key is turned from RUN to OFF and remains OFF for one
minute. It can also be armed manually by sending a Lock command (unless ignition key is in RUN position).
DISARMING
Antitheft system is disarmed for one minute when you send an Unlock command.
If ignition key is not turned to ‘RUN’ position within one minute, system automatically rearms, thus preventing an intruder
from starting your vehicle, even with ignition key. The indicator light (optional) blinks rapidly during rearming, and then
continuously when antitheft system is armed.
It can be connected so that horn sounds if an intruder tries to start your vehicle when antitheft is armed.
“ACTIVE" TYPE ANTITHEFT /
This type of antitheft system is armed by sending a ‘Lock’ command (unless ignition key is in ‘RUN’ position) and is
disarmed by sending an ‘Unlock’ command. The indicator light (optional) blinks continuously when antitheft system is armed
(if the AstroStart security system is not armed) .
VALET MODE (Antitheft)
The Antitheft function can be deactivated for the same reasons and in the same way as the Antitheft system. See "Valet
mode" details on page 14.
PARKING LIGHTS STATUS
The system can have the button blink on the remote control to warn you that the vehicle’s lights have been on for more
than ten seconds after the engine was stopped (additional optional equipment required).
The message is sent again after 30 seconds and then every two minutes for as long as the lights remain on.
This function is only available on gas-powered vehicles.
INDICATOR LIGHT
An optional indicator light (LED) can be added to the system to show the status of the safety sequence (on vehicles
equipped with a manual transmission), and the status of the safety system, the antitheft system or the Valet Mode.
See ‘Indicator Light’ in the ‘Safety System’ Section.
The following table shows the codes displayed by the indicator light when performing the safety sequence.
Repeated flashes Phase or Status
3 double flashes
Start of sequence.
2 double flashes
Door open.
1 double flash
Door closed (waiting for engine to stop).
1 single flash
Valid safety sequence (system is ready to receive a start command).
Fast (10 sec.)
Invalid sequence (sequence must be started over from beginning).
UTILITY COMMANDS
These commands allow you to control most of the vehicle accessories depending on what was connected during installation
(headlights, defroster, etc.). For more information, check with your technician.
To activate these functions, simultaneously press the buttons as shown in the following table.
The accessory associated to each of these commands is activated for the duration set at time of installation.
The delay can be canceled by repeating the command.
* Programmable at time of installation : The “trunk” command can activate the utility 1.
Remote control
Commands
4-button 5-button 6-button
Corresponding accessory Duration
UTILITY 1 *
UTILITY 2
-
UTILITY 3
- -
UTILITY 4
- -