Filter
Top Products
16
UNLOCK / DISARM
Press the
button, doors are unlocked and alarm is disarmed, parking lights flash and siren chirps twice to confirm
command has been received and that no alarm condition was generated during your absence.
If there was a violation, confirmation is different (4 flashes or chirps) to warn you. See table of alarm codes to know which
zone generated alarm condition.
The “Unlock“ function can be programmed and connected in such a way that the first Unlock command only unlocks the
driver's door, while a following Unlock command unlocks the other door(s).
Dome light will turn on for 30 seconds every time Unlock command is sent (not applicable in semi-passive mode)(optional
connection during installation).
This 30-second duration is cancelled when Lock command is sent, brakes are applied or key is inserted in ignition and
turned to RUN position.
TRUNK RELEASE
(This feature must be enabled during installation).
Press button as shown on following table. Trunk is released and parking lights flash three
times to confirm command has been executed. The remote shows the trunk opening.
Trunk cannot be released if ignition key is in “RUN” position.
Furthermore, if alarm is armed and system is not equipped with an additional sensor
capable of detecting trunk release (optional equipment not included), opening of trunk with
remote control will not be possible.
In this case, parking lights flash once and remote control vibrates once to confirm that command has been received but trunk
could not be released.
If you are not sure you have received confirmation, repeat command. System will repeat confirmation as often as you wish.
If your vehicle is equipped with a factory installed security system and that this system is neutralized by the trunk release
command, remember to rearm it after trunk is closed ("Lock" command).
SYSTEM EQUIPPED WITH AN ADDITIONAL SENSOR .
If your system is equipped with a sensor designed to monitor status of trunk (added at time of installation), parking lights will
flash three times to confirm command was received. When trunk is released, 3 chirps are emitted to warn that alarm will not
take into account the status of this zone or the shock sensor's zone for the next 5 minutes. If you do not release trunk within
10 seconds, the system will rearm trunk automatically.
The timer is reset each time the command is repeated, which allows a new 5-minute period to close the trunk lid.
The system will sound a chirp when trunk is closed to confirm it has been rearmed. If trunk is open for more than 5 minutes,
the system switches to alarm status.
AUTOMATIC LOCK/UNLOCK
Programmable as Active or Inactive during installation.
This function locks doors when ignition key is in ‘RUN’ position, engine is running and brakes are applied.
Doors are unlocked when key is turned from ‘RUN’ to ‘OFF’ or when Continuous Mode (Including Turbo Mode) is activated
or when a safety sequence is detected.
If Unlock function is set to unlock only driver's door on the first command, Automatic Unlock function will unlock driver's door
only. If dome light is connected to system, it comes on when an Automatic Unlock occurs.
This function is: Active
Inactive
.
OTHER COMMANDS
ANTITHEFT (CIRCUIT DISABLER)
Programmable as Active or Inactive during installation.
Your Remote Starter is equipped with an antitheft system. This system, when enabled, consists of an output that controls a
relay that cuts all circuits required to operate your vehicle (optional connection).
There are two types of antitheft systems.
Remote controls
4-button 5-button
> 5 sec.