Filter
Top Products
Page 6
OWNER’S GUIDE 2WAY REMOTE STARTER/ ALARM
Press and release button #1 to arm the alarm then press and release button #3
within three seconds. The system will chirp once when the lock button is
pressed and once when the start button is pressed. The shock sensor
will be disabled until the system is disarmed and the rearmed again
Press and release buttons #1 and #2 at the same time. If the doors were
locked this will unlock the doors without chirping the siren.
Note: The park lights will flash as confirmation of lock/ unlocking.
To Enter Shock Sensor Programming
Press and hold buttons #1 and #2 for three seconds. The park lights will flash
and the siren will chirp three times.
While the park lights are on strike the vehicle with the amount of force
wanted to trigger the alarm*. Hit the vehicle with the same amount of
force three time, the siren will chirp each time the system detects the
Impact
.
*Strike the vehicle with the palm of the hand, be careful not to impact
the vehicle in a area that may cause damage. The most common
location for testing and setting the shock sensor is the A-pillar. The A-
Pillar is the metal support that runs from the roof of the vehicle to the
hood area. Avoid hitting the windshield when programming the shock
Sensor.
Tempor ary Shock Sensor Bypass
Silent Arm and Disarm
Shock Sensor Programming/ Adjustment
Alarm Features
1
1
1
2
2
2
3
3
3
4
4
4