Filter
Top Products
2WAY REMOTE STARTER/ ALARM
OWNER ’S GUIDE
Page 3
Remote Start - Automatic Transmission Only
1.Press and release button #3.
2.The park lights will flash and the siren will chirp one time.
3.The vehicle will then remote start. The park lights will flash four times then
remain on while the vehicle is running.
4. The vehicle will run for the programmed runtime, (normally 15 minutes.)
Note: If the remote starter fails to start, the park lights will flash a Trouble Shooting
Code. Count the number of flashes and refer to the Diagnostics Chart.
Never remote start if the vehicle is parked in a Garage or attached
carport! Operate in a well ventilated area only.
Remote Stop
1.Press and hold button #3 for three seconds. The remote starter will shut down.
The park lights will flash and the siren will chirp two times to confirm shutdown.
Note: Pressing the brake pedal or opening the hood will also shut down the remote
starter.
Idle Mode
1.While the vehicle is running with key, press button #3.
2.The park lights will turn on and the siren will chirp once.
3.Turn the ignition key off and the vehicle will continue to run.
4. Exit the vehicle and leave it running safely without leaving the keys in the Ignition.
Lock the door while the vehicle is left running.
Extended Run Time
Turbo Timer Mode
1.While the vehicle is running with key, press button #4.
2.The park lights will turn on and the siren will chirp once.
3.Turn the ignition key off and the vehicle will run for approximately 2 minutes.
1.Press and release Button #3 while the vehicle is running under the remote starter.
The park lights will flash and the horn (optional) will honk to confirm the runtime has
been extended. The system will reset the runtime (normally 15 minutes).
Note: The Run timer is not updated with this feature.
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4