Filter
Top Products
10. Monitoring Activities
Users are able to setup and configure
monitoring activities and alerts to the
Vehicle Unit, using Control Base software or
Tracking Web services via Internet Explorer
or mobile on GPRS enabled cell phones.
Geo-Fence Alarms
¾ If the Vehicle Unit has been configured with a set of restricted
geographic areas (Geo-Fences), the following activities will be
triggered when a Geo-Fence violation occurs:
The Vehicle Unit will send an alarm message and GPS
coordinates to the Control Base. The Control Base software
will find the street name and closest intersection from a map
server and send these details through SMS short messages
to a list of up to three authorized Contact persons, with the
text:
Over Speed Alarms
¾ If the Vehicle Unit has been configured with a maximum speed
limit, the following activities will be triggered when the vehicle
speed exceeds the speed limit:
26
Peter’s truck is in Arlington.,
near intersection Fairfax
Ramp; GPS Car Alarm:
GEO Fence Alert
The Vehicle Unit will send an alarm message and GPS
coordinates to the Control Base. The Control Base software
will find the street name and closest intersection from a map
server and send these details through SMS short messages
to all Contact numbers, with the text:
Battery Low Warning
¾ If no main power source is connected and the included battery
pack in the Vehicle Unit runs low on power:
The Vehicle Unit will send an alarm message and GPS
coordinates to the Control Base. The Control Base software
will find the street name and closest intersection from a map
server and send these details through SMS short messages
to all Contact numbers, with the text:
27
Peter’s truck is in Highway
166, near intersection Gleebe;
GPS Car Alarm: Over Speed
Peter’s truck is in Madison
Ave., near intersection
Brixton Rd.; GPS Car
Alarm: Batter
y
Low
NOTE: Over Speed Alarms will only be reported if
ignition is on and the Vehicle Unit has been
connected to ACC (CON 2/ PIN 8).