Filter
Top Products
7. Activate/ Disable Vehicle Security
As an authorized Contact person, you are
able to activate and disable the vehicle
security system either from your GSM cell
phone (Caller ID must be enabled), Control
Base software or through user account from
one of the Tracking Websites.
¾ To activate the car alarm from a cell phone, place a 2-RING phone
call (ca. 5 sec.) to the Vehicle Unit number. This will lock the doors,
disable the ignition and activate the vibration sensor in the device.
Dial Call to Vehicle Unit Î 2 Rings ÎHang Up
In addition, you will receive an SMS short message from the device,
confirming that your vehicle is secured now.
¾ To disable the car alarm, place a 4-RING phone call (ca. 10 sec.) to
the Vehicle Unit number. This will enable the engine, and
deactivate the vibration sensor in the device.
IMPORTANT NOTE:
Please be aware that all cell phone numbers configured at the Control
Base as “Contact 1, 2 and 3” will be able to get notifications and remote
control security features of your vehicle that are significant for your
vehicle’s security, like:
Receiving SMS alarms and positions in case of unauthorized moving
of vehicle or opening of doors
Receiving SMS notifications in case of car accidents, emergency calls
or low battery warnings
Activate or disable the vehicle security remotely by phone call or SMS
Remote command central door locks, disable/ enable engine
immobilizer
Dial Call to Vehicle Unit Î 3 Rings… 4 Rings ÎHang Up
In addition, you will receive an SMS short message from the device,
confirming that your vehicle security is disarmed now
¾ To use SMS command to activate the vehicle security, type and
send this command to the Vehicle Unit to activate the security
system:
$ARM,1 Î Enter Vehicle Unit Number Î Send
¾ To use SMS command to disable the vehicle security, type and send
this command to the Vehicle Unit to activate the security system:
$ARM,0 Î Enter Vehicle Unit Number Î Send
¾ Alternately, you are able to activate or disarm the Vehicle Unit or
query its location and status over Internet Website or GPRS
enabled cell phones. Please refer to the Software or Web User
manuals to do this. Please note that security disable commands
sent from the Website will enable ignition and vibration sensor, but
not automatically unlock the vehicle doors.
¾ If your Vehicle Unit comes with an operational RF remote control,
you can use that remote control to lock and unlock the doors. This
will automatically activate or disable the security system as
described above.
19
NOTE: Only the Contact Numbers and Control
Base will be able to process remote commands.
Using other cell phones or dial-up software to send
commands to the unit will have no effect on the
Security System.