Filter
Top Products
* Receiver:
The receiver is tested and pre-attached to the rear panel of each W-series
model. Please do not try to remove it. The receiver responds to up to 5
different transmitters that are registered with the machine. The included
transmitter has been registered with the machine before shipment. It can be
directly operated without any start-up setting.
Registering transmitters
To operate the machine with a different transmitter than the included one, or
to operate it with up to 5 different transmitters, each transmitter must be
registered first. There is an LED indicator on each machine. On the W-508 it is
green and on the W-510 it is orange. When the machine is turned on, the LED
will be flashing for 15 seconds. During the 15-second interval, users can
register signals for one or more transmitters. For this purpose, press the
button “A” on each transmitter. If the registering signals of the transmitters
are well received by the receiver, the LED will stop flashing and light
permanently. The previous transmitters are cleared from the memory of the
receiver. If no transmitter is registered when the machine is switched on, the
memory of the receiver will keep the record of the previous operation.
Setting Example 1:
In order to register several transmitters with a machine, turn on the machine.
While the LED is flashing, press the button “A” on each transmitter to establish
the signal transmission.
Setting Example 2:
In order to use 1 transmitter to control 2 or more machines, turn on the
machines at the same time. While the LEDs are flashing, press the button “A”
on the transmitter to establish the signal transmission.
Battery change on the transmitter
If the range of the transmitter decreases, the battery is probably exhausted
-06-