Filter
Top Products
Note: An optoelectronic (OPTO) liquid sensor is installed in the W-508 & W-
510 Fog Machine. The pump will automatically stop working and the
LED indicator on the rear of the machine will start to flash when there
is insufficient liquid. Please refill liquid to the empty tank and restart
(turn off then turn on) to disengage the LED indicator. Then the
machine is ready to operate again.
If you experience low output, pump noise or no output at all, unplug
immediately. Check the fluid level, the external fuse, and power from the
wall. If all of the above appears to be O.K., plug the unit again. If fog does
not come out after holding the remote button down for 30 seconds, check
the hose attached to the tank to make sure there is fluid going through the
hose. If you are unable to determine the cause of the problem, do not
simply continue pushing the remote button, as this may damage the unit.
Return the machine to your Antari dealer.
W-1 Wireless Remote
The wireless remote control system W-1 consists of a transmitter equipped
with two buttons for fog on and off, and a receiver pre-attached to the rear
panel of each W-series model.
* Transmitter:
With the transmitter it is possible to emit fog via radio over a distance of up to
50 meters. The transmitter is compatible to any receiver of the W-series and
can control an unlimited number of machines in parallel.
Press the button “A”, to emit fog. As control, the blue LED lights. To stop the fog
output, press the button “B”.
-05-