Antari Lighting and Effects W-510 Automobile Accessories User Manual


 
This device is for adult use only and must be installed out of the reach of
children. Never leave the unit running unattended.
Never aim the output nozzle directly at people.
Fog machine output is very hot. Avoid coming within 50 cm of the output
nozzle during operation.
Locate the fog machine in a well-ventilated area. Never cover the unit's
vents. In order to guarantee adequate ventilation, allow a free air space of at
least 20 cm around the sides and top of the unit.
Never aim the output nozzle at open flames.
If the power cord is damaged, it must be replaced by the manufacturer or its
service agent or similarly qualified personnel in order to avoid a hazard.
The output nozzle becomes very hot during operation (200°C). Keep
flammable materials at least 50 cm away from the nozzle.
Always allow your Antari Fog Machine to cool down before attempting to clean
or service it.
Danger of Explosion
Never add flammable liquids of any kind (such as oil, gas, perfume) to the fog
liquid.
Use only high-quality, water-based fog liquid that your dealer recommends.
Other fog liquids may cause clogging or “spitting”.
Always make sure there is sufficient liquid in the tank. Operating this unit
without liquid will cause damage to the pump as well as over-heating of the
heater.
If your Antari W-508 or W-510 Fog Machine fails to work properly, discontinue
use immediately. Drain all fog liquid from the tank, pack the unit securely
(preferably in the original packing material), and return it to your Antari
dealer for service.
Always drain the tank before shipping or transporting this unit.
Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid
comes in contact with skin or eyes, rinse thoroughly with water.
Note: Pay attention to all warning labels and instructions printed on the
exterior of your Antari Fog Machine.
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to
operate the system has arrived intact.
The shipping carton should contain the following items:
1. One unit of W-508 or W-510 Fog Machine
2. Power cord
3. One set of W-1 Transmitter
-02-