Filter
Top Products
13
Remote control (RUE-4136)
a Avoid dropping this remote control or placing it in pants pockets. Doing so may cause
damage to the case or buttons, shorten battery life or cause the system to malfunction.
a To clean this device, wipe it with a dry cloth. (If it is extremely dirty, wipe it with a wrung
damp cloth.) Never use benzene, paint thinner or harsh chemicals which can cause
deterioration of the case or paint.
a Do not expose this remote control to direct sunlight (i.e. on the dashboard) for extended
periods of time.
Replacing the batteries
Use two AAA-type batteries.
Open the cover
1
Opening the battery cover.
Push on the cover and slide it as
indicated by the arrows then the
cover will be removed.
Replacing the battery.
Remove the old batteries. Insert
new ones matching the (+) and (–)
polarities as shown in the diagram
inside the remote control.
Closing the cover.
Push the cover in the arrow
direction until a click is heard.
2
Close the cover
3
Replace the
batteries
Tips
Remote Control Holder Installation
• If direct sunlight reaches the remote control
mounted on the holder, remove the remote
control from the holder and put it in the
glove compartment.
• If double-sided adhesive tape cannot install
the holder securely, use screws.
Note: Attach the blue protective paper side
of double-sided tape onto the console
box, etc.
Protective Paper
Console Box etc.
Reinforcing Screws
Remote
Control
Remote Control
Holder
Double-Sided
Adhesive Tape
(Before attaching
the tape, make
sure the mount-
ing location is
free from dust or
dirt.)