Filter
Top Products
Calibrating the Speedo to your motorcycle –
The speedo needs to let you know, accurately, what speed you are doing and what distance you have
done. You therefore need to enter a calibration code.
To do this, look at the attached chart which will give you a code dependent upon the tyre size that the
speedo reader head is mounted on. The chart will give you a code – 01, 02, 03.
To enter calibration mode;
Hold down the MOD button and THEN turn on the ignition. The speedo will show all “8’s” as it goes
through it’s lamp-test cycle, then will default to a flashing ‘01’. Using the INC and DEC buttons find
which code you need for the tyre size, then turn the ignition off. The 12V permanent power MUST be
maintained for at least 2 seconds after this operation or the unit will always default to a ratio of ‘01’.
Other Interesting/Technical Stuff!
Odo and Trip.
These two displays will show miles or kilometres; Miles when the Units are in miles, and Kilometres
when the units are in kilometres. They will re-calculate automatically to suit the speedo setting..
The ODO illuminates all the digits – leading zero’s if need be, eg 02497.5, while the TRIP does not have
leading zero’s, eg 2497.5
When in TRIP mode the INC button will increase it’s value and the DEC button will decrease it’s value.
You can increase or decrease the value by increments of 0.1, and if you hold the relevant button down,
the alteration will get faster and faster.
Clock
To set the clock; (note! The clock is 24 hour format)
Hold down the INC and DEC buttons together for around 5 seconds, until display changes to all zeros.
Use the INC button to add time and the DEC button to lose time.
Holding either button down will alter the clock at a quicker and quicker rate.
Touching the relevant button momentarily will alter the clock by one minute at a time – and also clears
the underlying seconds to accurately set the clock.
To end set-up press the MOD button.
If during clock set-up you;
Don’t do anything in set-up mode for two minutes; or
Scroll through the MOD button; or
You turn off the ignition
The set-up mode is exited.
If the permanent 12V is removed, the clock will, after a period of about 10 minutes, lose it’s time and
need to be reset. It will start up at 00-00.
Page 5