Acumen CAT21 Automobile Alarm User Manual


 
Customising the system
4
Section 1. Full Mode
The unit will arm, in it's default setting, 50 seconds after the ignition is
turned off and will only detect an ignition on signal. To passively arm
the system automatically with all functions enabled simply fix the
Yellow wire from the alarm to a suitable earth (ground) point.
A. If the movement sensor is active, the system LED will flash once
every second.
B. If the system is in Convenience Mode (see section 2), the LED will
flash once every two seconds.
C. If you manually arm the CAT21 system within the 50 seconds auto
arm time, by pressing the ‘key’ button, the system will arm with the
movement sensing active.
Section 2. Convenience Mode
During day to day use of the motorcycle there are times when full
passive arming with movement sensing can be inconvenient e.g. filling
with fuel or parking momentarily while opening a garage door.
A. Where the system is installed to arm all sensors automatically
when the ignition is switched off, (i.e. yellow wire permanently
grounded) convenience mode can be selected by pressing ‘P’ on
the key fob transmitter after the system arms. (Passive arming
takes place 50 seconds after switching off the ignition.
B. To avoid waiting for the system to arm automatically press the ‘key’
button once to manually arm the system before the 50 seconds
elapses and then the ‘P’ button to enter Convenience Mode.)
Section 3. Service Mode
There may be times when you really don’t want the
system on the motorcycle. Such as when cleaning, or performing
service work. The CAT21 has a service mode which effectively makes
the CAT21 system transparent.
To enter Service Mode, disarm the system, switch on the motorcycle
ignition. With the ignition on press and hold the key button until the
system gives a ‘beep’ (two to three seconds). This denotes the system
has entered service mode.
In Service Mode, the alarm will beep once every 60 seconds. (If you
get more than one beep see section 4), and the LED remain on and will
not flash.
If the alarm is left in Service Mode for over 24 hours, the beep will be
switched off.
RReemmeemmbbeerr
in Service Mode your motorcycle is totally
unprotected - the LED will serve as a reminder!
If you are storing your motorcycle, and need to move the motorcycle
now and then, we suggest you arm the system and place it into Full
Mode.