Filter
Top Products
8
P5000 Series Owners Manual 12/16/04 5:16 PM Page 8
Attach sensor cable extensions and cable tie the sensor cables to conceal.
Be certain the cables will reach the control module then fasten the control
module using the screws provided. Attach the sensor cables to the control
module. Be sure to match the correct sensor location with the module inputs.
Clean the display location with alcohol and attach display to dash. Run the
display cable through an existing grommet. Cut grommet if necessary to
run the cables through. If there is no access from the cab drill a hole suitable
for the cables to pass and line with a grommet. Run display cable to control
module and attach. Cable tie the display cable and conceal
(5000 Wireless use Display) Splice red (+) power lead into a keyed circuit
or run to fuse box. Splice or attach black (-) ground wire to sufficient ground.
Clean the display location with alcohol and attach display to dash. Cable tie
power cable and conceal.
Identify the power wire to the reverse lights using a test light. Connect the
Red positive wire from the control box to the reverse lights positive lead,
and the Black ground wire to the reverse light's ground or other ground
using the splice connectors supplied. Electrical tape or shrink-wrap the
splices for additional protection
IV. System Check:
A. Re-connect battery
B. Engage brake, turn the ignition on
C. Shift transmission into reverse and make certain reverse lights are on.
Two beeps from the display indicates the system is active.
D. Note detection patterns and alerts levels below.