Filter
Top Products
6
P5000 Series Owners Manual 12/16/04 5:16 PM Page 6
Flush Mount
Next locate an imaginary line on the bumper where you would like to align
the sensors, that is relatively flat and between 1.5' - 2' from ground level.
Place a mark at the intersection of the bumper center-point and the sensor
height point.
Near the ends of the bumper, mark the same sensor height on masking
tape creating 3 points along the bumper. Run a strip of tape so the top of
the tape connects all 3 points. (These points will form the drill line), mark
with additional strips of tape. To protect the rear corner of the vehicle,
mount sensors within 1' from the edge.
45-60cm
1/8
approx approx
1/8
approx
2/8
approx
2/8
approx
2/8
Each surface mount sensor comes with 3 different angled rubber shims,
which can optionally be used to adjust the sensor angle if the mounting
position would otherwise be too low.
Surface mount
Sensors may be mounted below or above the bumper. To protect the rear
corner of the vehicle, mount sensors within 1' from the edge. Place the
sensors at the desired locations and mark drill holes with a felt tip marker.
Prior to drilling, check the underside of the bumper to be certain that there
are no wires or items that may be damaged by the drill bit. Drill using
the bit with proper size. Screw sensor onto bumper.