Filter
Top Products
5
P5000 Series Owners Manual 12/16/04 5:16 PM Page 5
surfaceflush mount mount
Begin by parking on a flat level surface, set brake and disconnect ground
wire from battery. Measure the length of the bumper and mark the center
point with a mark on masking tape. Divide the bumper as shown below.
To protect the rear corner of the vehicle, mount sensors within 1' from
the bumper ends.
NOTE:
The driver's side is considered the left side of the vehicle.
The sensors are marked:
R=Right, CR=Center Right, CL=Center Left, L=Left
II. Sensor Installation
Sensor installation will depend on the sensors supplied with the system
either flush mount or surface mount. Locate your sensor type from the
sensors below.
45-60cm
1/8
approx approx
1/8
approx
2/8
approx
2/8
approx
2/8
flush mount with
adjustable angle