Xanté 3 Series Manual

A SERVICE OF

next previous

3-42 Macintosh Setupbb ____________________________________

1. Open XANTÉ Command Center if necessary; then, select

General: X-ACT. The More X-ACT Calibration window

appears (fig. 3.19).

Fig. 3.19 More X-ACT Calibration Window

2. Make sure that the same type of media you will use for final

printing is loaded in the printer.

3. Select a setting for the media type you are using from the

Media Type drop-down menu (fig. 3.20).

Fig. 3.20 Media Types Menu