Adjustment Using the Menus
24
AUDIO SETTING
REMOTE menu
768 × 480 (575i, 576P)
–
The image is scaled horizontally to display in an aspect
ratio of 4:3.
Submenu Setting
SDI AUDIO SETTING Sets the audio channel when SDI
signal is input.
• 3G/HD/SD: Selects from among
channels CH1 to CH16, odd
channel + even channel
(CH1+CH2,
CH3+CH4···CH15+CH16)
and OFF.
You can display the L/R audio
levels of the selected channels on
the display when the WFM/ALM
display is enabled (see “WFM/
ALM (waveform monitor and audio
level meter) DISPLAY SETTING”
on page 21).
INPUT
3
16
9
NATIVE
(480i, 575i,
480P, 576P
645 × 480 (480i, 480P)
SDI AUDIO SETTING: xxx
3G/HD/SD: xxx
USER CONFIG – AUDIO SETTING
PARALLEL REMOTE:
SERIAL REMOTE: xxxxxxx
MONITOR:
CONTROLLER:
CONNECTION: xxx
REMOTE
Submenu Setting
PARALLEL REMOTE Selects the PARALLEL REMOTE
connector pins for which you want
to change the function.
You can assign various functions to
1 to 4 pins and 6 to 8 pins. The
following lists the functions you
can assign to the pins.
• – – – (“– – –”: No function is
assigned.)
•COMPOSITE
•SDI
• HDMI
• OVERSCAN
•FULL
• NORMAL
• NATIVE
•4:3
•16:9
• TALLY R
• TALLY G
• BLUE ONLY
• MONO
• H/V DELAY
• 16:9 MARKER
• 15:9 MARKER
• 14:9 MARKER
• 13:9 MARKER
•1.85:1 MARKER
•2.35:1 MARKER
• 1.85:1 & 4:3 MARKER
•4:3 MARKER
• CENTER MARKER
• MARKER MAT HALF
• MARKER MAT BLACK
•WFM/ALM
Notes
• If you use the PARALLEL
REMOTE function, you need to
connect cables. For more details,
see page 28.
• Set MARKER ENABLE
(page 21) to ON to control the
aspect marker and center
marker.
