Chapter 6 System Connections and
Settings
6-6
Chapter 6 System Connections and Settings
When using the BVE-2000
Control the M/E and downstream keyer through the 9-pin connector. You
can control M/E and downstream keys simultaneously.
A/B roll editing system connections (2) — using the BVE-2000
Player VCR A
Player VCR B
Recorder VCR
DFS-700/700P control panel
DFS-700/700P
processor
SRP-L300 Delay Unit
SRP-V200R Audio Mixer
BVE-2000 Editing Control Unit
Video and audio signals
Control signals
Black burst signal (reference
synchronizing signal)
Cables used
1 These depend on the type of VCR being connected. Check with the instructions
supplied with the VCR.
2 XLR (3-way) cables
3 RCC/5G/10G/30G 9-pin remote control cables
4 RCC11A audio mixer control cable
Connections for an A/B Roll Editing System
Chapter 6 System Connections and
Settings
Chapter 6 System Connections and Settings
6-7
Setup Menu Settings
Setup Menu Organization
The setup menu is divided into eight pages, and each appears as shown in
the following example.
Example display:
System Setup (page 1/8)
F3(PORTS) setting and control
Menu name
Settings
Page
Values
To submenu
Button
Setting Meaning Values
(First value is factory default.)
F1
SCREEN
Set screen aspect ratio. 4:3/16:9
F2 PRE RD Toggle preread editing on/off.
When this is on, a “P” appears at the
beginning of line two of the menu
display.
OFF/ON
F3 PORTS Select type of editor connected to
EDITOR connector.
(See table below.)
PVE-500/BVE-600/GPI
(Select “PVE500” when a BVE-2000 is
connected.)
F4
TALLY Toggle rear panel tally output signal on/
off.
OFF/ON
F5
CpnIN
(Only appears when
optional BKDF-702/702P
is installed.)
Assignment of
numbers to rear panel
COMPONENT
connectors
5
/
1
to
8
/
4
IN1-4 r: assign 1
to 4.
1-4/5-8
To confirm displayed assignment, press
F3(OK); to cancel press F5(CANCEL).
IN5-8 r: assign 5
to 8.
Values Valid control for each connector
EDITOR connector GPI/T 1 GPI/T 2
PVE-500 DVS control – DSK transitions
BVE-600 – Auto transitions
GPI – Auto transitions DSK transitions
A “P” appears here when
preread editing is on.
