FIGURE 31
4. Lubricate Grease Fittings: There are six grease zerks on
the tractor located as follows: two on the front spindles
and one on the steering bearing housing, power take-off,
right
rear
axe1
and clutch. Give each zerk about 3 shots of
automotive type grease every 25 hours. See figures 32
through 36.
FIGURE 35
6. Lubricate Pivot Points: Place a few drops of engine oil
on all pivot points to reduce wear and provide for easier
operation. See figures 36 through 38. Be careful not to get
oil on belts or pulleys as it may cause slippage. Place a film
of grease on the steering gear sector. See figure 36.
FIGURE 32
FIGURES 33
&
36
FIGURE 34
5. Check the Oil Level in the gear box located above the
power take-off. Turn the pipe plug counterclockwise to
re-
n~ove.
The oil should be level with the top of the elbow at
the rear of the gear box. If necessary, add SAE 90 wt.
transmission oil. Reinstall the plug securely. See figure 35.
