18
How to adjust the transmitter frequency
Adjust the desired transmitter frequency with the switch ᕥ. Each number on the
switch corresponds to a transmitter frequency. You will find the exact frequency
on the type plate in the battery compartment.
̈ Take care that the transmitter frequency and the received frequency selected
at the receiver do correspond.
̈ A small screw driver (breadth approx. 2 mm) or the end of the wire antenna
which is shaped like a small blade is suitable tools for the selection.
How to switch on / how to select sensitivity
The ON/OFF-switch ᕦ and the selector switch ᕧ are positioned in a cavity on the
bottom of the housing.
̈ The ON/OFF-switch which is used more frequently is positioned slightly
above the selector switch.
After having switched on the transmitter you must wait approx. 2 seconds as the
transmitter requires this time for adjusting to the chosen frequency. (PLL-rest.).
The AF signal is attenuated if the selector switch for the sensitivity ᕧ is switched
to „LOW“. Close-miking can thereby not result in overmodulation.
̈ Attenuation for SKM 1030: approx. 14 dB
̈ Attenuation for SKM 1032: approx. 20 dB
ᕦ
ᕤ
ᕧ
ᕤ
ᕥ
