Warranty - Page 79
WARRANTY
WARRANTED PARTS
Coverage under this warranty extends only to the parts listed below (the emission control system parts) to the extent these
parts were present on the engine purchased.
Since emission related parts may vary slightly from model to model, certain models may not contain all of these parts and
certain models may contain functionally equivalent parts.
WARRANTY SERVICE AND CHARGES
Warranty service shall be provided during customary business hours at any authorized John Deere Commercial and
Consumer Equipment Retailer located within the United States of America. Repair or replacement of any warranted part
will be performed at no charge to the owner, including diagnostic labor which leads to the determination that a warranted
part is defective, if the diagnostic work is performed at an authorized John Deere Commercial and Consumer Equipment
Retailer. Any parts replaced under this warranty shall become the property of John Deere.
MAINTENANCE WARRANTY COVERAGE
a) Any warranted part which is not scheduled for replacement as required maintenance shall be warranted as to defects for
the warranty period. Any such part repaired or replaced under the warranty shall be warranted for the remaining warranty
period.
b) Any warranted part which is scheduled only for regular inspection to the effect of “repair or replace as necessary” shall
be warranted as to defects for the warranty period. Any such part repaired or replaced under the warranty shall be
warranted for the remaining warranty period.
Fuel Metering System: Fuel Metering System:
Carburetor and internal parts (or fuel injection system).
Cold start enrichment system.
Air/fuel ratio feedback and control system.
Air Induction System: Air Cleaner
Controlled hot air intake system.
Intake manifold.
Particulate Controls: Traps, filters, precipitators, and any other device used to capture
particulate emissions.
Exhaust Gas Recirculation
(EGR) System:
EGR valve body and carburetor spacer if applicable.
EGR rate feedback and control system.
Ignition System: Spark plugs.
Magneto or electronic ignition system.
Spark advance/retard system.
Air Injection System: Air pump or pulse valve.
Valves affecting distribution of flow.
Distribution manifold.
Catalyst or Thermal Reactor
System:
Catalytic converter.
Thermal reactor.
Exhaust manifold.
Miscellaneous Items Used
in Above Systems
Vacuum, temperature, and time sensitive valves and switches.
Electronic controls.
Hoses, belts, connectors, and assemblies.
