A SERVICE OF

logo

60 ST80 Maxiview Operation & Setup
Chapter 5: Problem Solving
5.1 Problem Solving
Display is blank
Make sure that the power supply is connected.
Check the fuse or circuit breaker.
Make sure that the SeaTalk cables are not damaged.
Check the contrast and illumination settings
Faulty LCD module.
No exchange of information between SeaTalk instruments
Make sure that the cables are attached securely.
If the problem persists, disconnect your instruments one by one to
isolate the faulty unit.
Failure of a group of SeaTalk instruments
Make sure that the SeaTalk connections to non-functioning
instruments are secure.
LCD shows “Code ON” when the power supply is
switched on
The CodeLock anti-theft system is operational.
Poor character definition
Adjust the contrast.