A combination antenna receives
normal broadcast channels
(VHF 2-13 and UHF 14-69).
Your connection is easy since
there is only one 75C_ (ohm)
antenna plug on the back of your
TV - and that's where the antenna
goes.
,_ If your antenna a
has Found
cable (75 ohm) on the end, then
you're ready to connect it to the TV.
If your antenna has flat twin-lead
wire (300 ohm), you first need to
attach the antenna wires to the screws
on a 300 to 75 ohm adapter.
,_ Push the round end of the
adapter (or antenna) onto the 75_
plug on the rearof the TV. If the
round end of the antenna wire is
threaded, screw it down tight.
Note: For homes with separate UHF and VHF antennas
you will need an optionalcombiner to connect to the TV.
u/v
Combiner
Back of TV
75-300 Ohm Adapter
Remember: t
Be sure to set the
TV for the type sig-
nal you've connect-
ed (see the "Tuner"
section on page I I
of this manual.)
To set the TV to
select only the chan-
nel numbers in your
area see how to
"Program" or "Add"
channels in the TV's
memory on page 12
(Auto Program sec-
tion).
To order any option-
al accessory contact
your dealer or the
Philips Parts Center
at 1-800-851-8885.
Combination VHF/UHF
Antenna
(Outdoor or Indoor)
Back of TV
Round Cable
7512
