y;ur television comes with an
nscreen clock. During normal
operation the clock appears on the
screen when the STATUS/EXIT but-
ton is pressed or when channel
changes occur
<_ Press the CLOCK button on
the remote to display the onscreen
CLOCK menu.
_ Press the CURSOR UP • OR
CURSOR DOWN • buttons until
the words SET CLOCK are high-
ghted.
<_;_ Enter the current time using
the NUMBERED buttons. If the
first number is a single digit first
enter a zero then the dig!t (i.e.,
press 0 , then press "8 ).
<_ Press the CURSOR RIGHT •
or CURSOR LEFT ,_ buttons to
set either AM or PM time.
Note: The CLOCK onscreen menu
can also be accessed through the
main menu by pressing the MENU
button; then scrolling up/down
with the CURSOR UP • or
CURSOR DOWN • buttons until
the word CLOCK is highlighted.
Press the CURSOR RIGHT •
button to activate the CLOCK
menu and follow the steps above to
set the time.
Remember: Be sure to
[[ press "0" first and then the
hour number for single digit
entries.
To clear the onscreen menu press
the STATUS/EXIT button or wait a
few seconds after you have fin-
ished your adjustment and the
menu will automatically disappear
from the screen.
JcK --:--AMI
T1MERACTIVE ON
CHANNEL 12
[SETCLOCK 10:00 AMI
TIMERACqqk_ ON
CHANNEL 12
lafpTat_mnesicSSee_,.thetime will not
Note: The CLOCK onscreen menu can
also be accessed through the main menu
by pressing the MENU button; then
scrolling up/down with the CURSOR
UP • or CURSOR DOWN • buttons
until the word CLOCK is highlighted.
Press the CURSOR RIGHT • button
toactivate the CLOCK menu and follow
the steps above to set the time.
17
