13
Set clock
1 In standby mode, press and hold
CLOCK/DISPLAY to activate the clock
setting mode.
[SET CLOCK] (set clock) is displayed »
briefl y. Then the hour digits are
displayed and begin to blink.
2 Press VOL +/- to set the hour.
3 Press CLOCK/DISPLAY to confi rm.
The minute digits are displayed and »
begin to blink.
4 Press VOL +/- to set the minute.
5 Press CLOCK/DISPLAY to confi rm.
Turn on
1 Press on the main unit.
The unit switches to the last selected »
source.
Switch to standby
1 Press to switch the unit to standby
mode.
The backlight on the display panel »
turns off.
The clock (if set) appears on the »
display panel.
1 Switch the voltage selector to the local
power line voltage.
2 Connect the power cord to the
AC~MAINS jack on the main unit.
3 Connect the power plug to the wall
outlet.
Install remote control battery
Caution
Risk of explosion! Keep batteries away from •
heat, sunshine or fi re. Never discard batteries
in fi re.
Risk of decreased battery life! Never mix
•
different brands or types of batteries.
Risk of product damage! When the remote
•
control is not used for long periods, remove
the batteries.
For fi rst-time use:
1 Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1 Open the battery compartment.
2 Insert 1 CR2025 battery with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
AC MAINS ~
English
EN
