A SERVICE OF

logo

Open as PDF
next previous
41EN
EnglishFrançaisEspañol
ConnectingtheTVtotheinternetusinganEthernetcable
LAN
LAN WAN
54321
hubor
broadbandrouter
telecommunications
equipment(modem,etc.)
Ethernetcable
Ethernetcable
internet
Note
•
Please purchase shielded Ethernet cables at your local store and use them when you
connect to network equipment.
• After connecting an Ethernet cable, set up necessary network settings. (For the
network setup, refer to ‘Network’ on page 30.)
• Do not insert any cable other than an Ethernet cable to the Ethernet port to avoid
damaging the unit.
• If your telecommunications equipment (modem, etc.) does not have broadband router
functions, connect a broadband router.
• If your telecommunications equipment (modem, etc.) has broadband router functions
but there is no vacant port, use a hub.
• For a broadband router, use a router which supports 10BASE-T / 100BASE-TX.
• Do not connect your PC directly to the Ethernet port of this unit.
ConnectingtheTVtotheinternetusingawirelessLAN
LAN
WAN
WirelessLAN
AccessPoint(AP)
(e.g.wirelessrouter)
networkequipment
(modem,etc.)
Ethernetcable
internet
Note
•
After you made the wireless connection, set up necessary network settings.
(For the network setup, refer to ‘Network’ on page 30.)
• Use a Wireless LAN Access Point (AP) (e.g. wireless router) which supports IEEE
802.11 b/g/n. (n is recommended for stable operation of the wireless network.)
• This unit does not support Ad-hoc mode.
• Other radio devices or obstacles may cause interference to the wireless network
connection.
Connectingadigitalhometheateramplierusingadigital
audiocoaxialcable
DIGITAL AUDIO
IN
OUT
OUT
digitalhometheateramplier
Note
•
Due to Copyright restrictions, the broadcaster may choose to mute PCM audio over
Digital Audio Output for certain channels, shows or segments during the broadcast.