26 51-3849, 5/26/06
MAINTENANCE SECTION
MAINTENANCE SCHEDULE
Maintenance Schedule
Procedure Before After 100 500 See Prime
Each Use Each Use Hours Hours Mover
Manual
Brush head assembly - Level
Brush pattern - Check (See Pattern Adj. Section)
Cylinders - Retract rods
- Grease threaded and ball ends to
prevent rust
Drive shaft, pump - Check (AH/CH; Power Pack)
Filter, air, prime mover - Clean
Filter, hydraulic - Replace (AH/CH)
Fittings/hoses, hydraulic - Check for leaks/tighten
Check for damage
Fittings, zerk - Grease. (See lubrication points)
Oil, hydraulic - Check Level (AH/CH)
- Replace (AH/CH); use ISO
VG-46 hydraulic oil
Hardware - Check for tightness
Swing plate - Grease (CH/RLH/RLCH/Loader)
