A SERVICE OF

logo

Open as PDF
next previous
51-3849, 5/26/06 15
INSTALLATION SECTION
AH/CH
Swing Cylinder
Figure 4 shows the cylinder fully installed.
1. Connect a hose to each fitting on the cylinder.
2. Attach adapter fittings to hose ends.
3. Connect adapter fittings to remote valves (manual
valves) or the Up port (electric valves).
Lift Cylinder
Figure 5 shows the lift cylinder fully installed.
1. Slide the rod end of the cylinder through the plate on
the swing plate upright. Install flat washer and secure
with a nut.
CAUTION - Avoid cylinder damage. Only place 1 nut on
the rod.
2. Attach the barrel end to the center ear on the brush
head upright. Use the clevis pin and hairpin clip
provided.
3. Connect a hose to the elbow fitting on the cylinder.
4. Connect the hose to the first valve that has a single
port (manual valves) or the L port (electric valves).
figure 4
figure 5